Ford Tps Sensor Wiring. This is the gray w/ white. Connect your multimeter's black test lead to circuit #1 and the red lead to the battery positive (+).
2) locate the throttle position sensor (tps) on the throttle body. Web wiring | ford tps | small round | connector | pigtail. “tap” the green wire on the tps with the red wire of the dvom.
As the engine in your pickup or van idles (and the throttle plate is closed), the throttle position. This is the gray w/ white. Web wiring | ford tps | small round | connector | pigtail.
Place your multimeter in volts dc mode and connect the red test lead to the wire that connects to circuit #2 of the tps connector. Web this sensor gives the engine control unit information about the position of the butterfly valve. Connect your multimeter's black test lead to circuit #1 and the red lead to the battery positive (+).
Web turn on your digital volt/ohm meter (dvom) and set to dc volts. Reviews (0) factory correct connector with wire leads for the so commonly damaged tps wires in mid 80's. 2) locate the throttle position sensor (tps) on the throttle body.
Web 1) disconnect the negative battery cable. Connect the red multimeter test lead (using the. It is used to detect the idle position, wide open throttle state of the valve.
Disconnect the tps from its electrical connector. Check circuit #1 for ground with the key on engine off (koeo). Web the throttle position sensor gets 5 volts and ground from the ecm.
